No products
Prices are tax included
All useful and not always easy to find accessories are here:
spare filter cartridges
tap and quick-fit fittings for filters
aerators for swivel jet taps
3-way mixing valve for water purifiers...
1 silicone gasket
Provide a tight seal between the quartz tube and the stainless steel reactor.
It is very useful in plumbing:
Hose for osmosis machine - water purifier - refrigerator.
Diameter 6.35 mm - 1/4 " inch.
Sold by the meter.
1/4 fitting for plastic food pipes from 6mm to 6.5mm.
3/8 inch (12-17) connector for 6 mm to 6.5 mm plastic food hoses. (1/4 inch)
Automatic push-fit fitting - 90° elbow - for 6 mm to 6.5 mm (1/4 inch) plastic food pipes
3/8 inch (12-17) female fitting for 6 mm to 6.5 mm (1/4 inch) plastic food tubing
Straight push-fit fitting for 1/4 - 1/4 - plastic food pipe tolerances from 6 mm to 6.5 mm (1/4 inch)
Connect your modular filter holders together easily.
This accessory provides an instant seal without the need for screws or consumables.
Easily install your modular filter holder with these two 20/27 (3/4") connectors.
These accessories allow you to adapt the two outlets of the filter holder to the thread size required for your project.
Easily install your modular filter holder with these two 26/34 (1") connectors.
These accessories allow you to adapt the two outlets of the filter holder to the thread size required for your project.
Easily install your modular filter holder with these two 15/21 (1/2") connectors.
These accessories allow you to adapt the two outlets of the filter holder to the thread size required for your project.
Easily use your modular filter holder with these two 6 mm (1/4") tube connectors.
These accessories allow you to adapt the two outlets of the filter holder to a 1/4" automatic connector.
A simple, effective spanner
to loosen the tanks of your modular filters.
A dedicated product for connecting a filter / filter holder
This type of fitting allows you to adapt a 3/8" tube to a 1/4" inch tube
3/8" corresponds to 9.52mm with a tolerance of approximately 8 to 10mm.
1/4" corresponds to 6.35mm with a tolerance of approximately 6 to 7mm
An essential accessory for filter doors.
These rings make it easy to centre the filter cartridges so that they are properly aligned when reassembled.
For 10-inch filter holders.
You've dropped your bowl and it's broken.
Here's the complete replacement part:
- the bowl (BPA-free)
- the O-ring
- the purge complete with locking shim
- the clamping locking system
For standard 10" inch filter holder.
The essential accessory for your filter.
Easily connect a water filter under your kitchen sink.
This regulator protects water purifiers, osmosis units and other appliances.
Some homes don't have a pressure relief valve to protect their pipes, so this accessory is needed to prevent water hammer and excessive pressure in the pipes.
Ideal for use with a 1-tank water filter
and those who are short of space.
compact 2-in-1 cartridge:
The essentials of water treatment in a single filter cartridge.
For standard 10" inch filter holder.
High-efficiency cartridge.
Fits a 10-inch filter holder.
Specifically designed to remove iron, manganese and hydrogen sulphide
Anti-bacterial.
Cartridge suitable for 10-inch filter doors.
For 10-inch filter holder - FLAR
Electronic control unit specific to the UVc steriliser
It allows a UVc lamp to operate continuously.
It is equipped with a red or green LED that lights up depending on the status of the lamp.
No products
Prices are tax included