No products
Prices are tax included
Anti-limestone magnet 10800 gauss Mi Power
Recommended for a small home.
Ecological protection against scale.
Much more pleasant water:
- More foam with your soaps
- Shampoos that give better results, lighter and shinier
- Energy savings to heat water.
- Easy fixing with the supplied clamps.
How does it work and is it difficult to install?
It is simply installed by assembling the 2 parts it forms around the water pipe you want to treat. Water, by crossing the overpowering magnetic field of rare earth neodymium magnets, will act on minerals and other materials suspended in the water, causing them to lose their adherent property. This state of crystallization of water in the form of aragonite will last at least 24 hours before it recovers its initial properties.
In most homes, it takes much longer than it takes for your water to move between your water supply and its exit to the sewer and the wastewater system.
Where should it be placed and is it the right model?
The Mi power magnetic softener is installed in the main water pipe to treat all the water in the house (cold and hot). It is designed for pipes with an internal diameter of less than 16 millimetres, which corresponds to a water flow rate of approximately 20 litres per minute. This is generally the maximum water flow rate used by a family of less than 4 people with one bathroom.
Please note that for convenience and to avoid having large quantities of pipes with different diameters, installers often use a pipe of 25mm or more, the main pipe in your home may be larger than necessary. To avoid buying a more expensive model unnecessarily, you can check for yourself the diameter you should have on your home: method of calculating the main diameter of a house pipe
To optimise the results, it can be installed after a double or backwashable water filter as softeners do not remove impurities from the water.
About "hard water" and "fresh water"?
This system eliminates the costly and polluting disadvantages of ionic softeners (salt softeners)
Water travels through soil and rock to reach the groundwater table, dissolving very small quantities of minerals and other materials during its journey that will solubilize in the water. Calcium and dissolved magnesium are the two most common minerals that make water "hard". The degree of hardness becomes greater as the amount of calcium and magnesium increases. It is these minerals that cause scale or limescale deposits when they are deposited.
Water is a good solvent and many beneficial or impure particles will bind to it through the long journey that will lead it into our homes.
If we want to reduce this amount of calcium, magnesium and other substances in water, it must be acidified by a treatment that is often chemical and not natural. There is no interest other than that of maintenance, we also lose elements that are rather favourable to health through this process.
A more interesting alternative is to preserve water quality by only modifying its structure.
What are the advantages of our magnetic anti-limestone 10800 gauss Mi Power
In a few months, you will start saving money and energy, and over the years, you will save money because your accessories and devices will last longer. Limescale deposits in your plumbing will be greatly reduced in just a few months
Your water heater will use less energy and last longer.
After a few days of use your skin will be softer, less dry and you will feel less itching. Your hair will be silkier and easier to style.
After a few days, dishes washed by hand or in a dishwasher will be easier to clean and stain-free.
You will use less detergent and less laundry for dishes or baths.
Kitchens and bathrooms will find taps and accessories easier to clean and maintenance much more distant.
Characteristics of the Mi PowerWater conditioner, scale inhibitor, better than a water softener
◆ Simply installed around your piping.
◆ The Mi Power contains powerful permanent magnets and can therefore be used continuously without an external power supply.
◆ Improvement of water quality without the use of chemicals and without polluting discharges.
◆ As it is installed outside the pipe, it is maintenance-free.
◆ Investment within everyone's reach, dismountable, no need to own your home to enjoy it!
How does a magnetic limescale remover work? Does it work? Do the magnets wear out? Does it remove limescale?
Download (6.61M)
Installation tips
- The anti-limescale device will be installed in the main pipe.
It does not matter whether it is before or after the water meter. - The device can be installed in any direction.
- In one of the two parts of the system, the nuts are already integrated.
- The additional nuts are to be screwed on the screw head side.
They are used to tighten the two parts of the anti-limescale system together without the threaded rod protruding and interfering with the installation. - The larger the diameter of the pipe, the larger the space between the two parts of the system.
This gap does not hinder the effectiveness of the system, as it allows the magnets to be as close to the pipe as possible. - In order for the field to act properly on the water flow, they must attract each other.
Good practices for optimal operation
This system should not be installed on pipes that magnetise.
There is therefore no contraindication for plastic pipes, copper, aluminium, etc...
A simple check can be carried out with a standard fridge magnet:
- if the magnet is not attracted to the pipe, installation is possible.
If not, simply insert a section of non-ferrous pipe of your choice and of the right length so that the magnetic field can act.
This dismantling can also be a good opportunity to install a filtration system.
The magnetic fields of the Mi Power do not affect nearby electrical appliances. Only small electronic devices such as watches, calculators or magnetic bank cards could be affected in their operation if placed directly on the magnet.
For optimum effectiveness, please install the Mi Power as close as possible to your home or to the items to be treated.
A distance of more than 40 metres will greatly reduce the effectiveness.
Installation of an anti-limescale with a filter
Magnetic scale removers are not curative. They will not destroy the deposits that have formed in the water pipes that supply your installation before your water meter.
So sludge, sand and other impurities could continue to accumulate in your boilers, water heaters and other taps...
Sometimes filings or iron particles can be found in the water. Filtration will have the advantage of retaining them and preventing them from gradually accumulating in the magnets. The anti-scale operation and the good flow of the water would then be disturbed.
You will have understood that a water filter is strongly recommended to optimise long-term operation.
Technical document
- Dimension 65 x 50 x 28 mm - 1 pair
- For pipes outside diameter: from 14 to 25 mm
- Minimum distance between the pipe and the wall: 7 mm
- Max flow rate 20l/min or 1,2 m3/h
The general water supply pipe is often oversized, that's why the system can be installed on pipes up to 25mm but the maximum water flow that can be treated should not exceed 20l/min which corresponds to a pipe with an inner diameter of 18mm.
If necessary, check this diameter with the calculation method in our blog:
SIZING THE MAIN WATER PIPE OF A DWELLING
For a higher water flow rate or a more calcareous water, by installing several devices the efficiency will be improved.
The two magnetized parts must also be placed in opposition of pole (i.e. attract each other)
Magnetic anti-limescale devices can be installed on any type of pipe except those containing iron (which can be magnetized)
(135)
(31)
(7)
(1)
(3)
(1)
Easy to install and good water
Water filter option
|
Disregard this box, which is not a product. The total will be updated at the bottom of the options and on the product price. |
|
Automatic self-cleaning filter Equipped with a pressure reducer and pressure gauge
An upgradeable system |
|
Allows you to create 2 filtration stages
Don't forget to order the appropriate 10" inch cartridges. |
|
BPA-free modular filter holder- Bare model without connectors Can be used with standard 10" inch cartridges:
Cartridges and connectors can be seen at the bottom of the page |
|
A simple, effective spanner |
|
3/4’ connector (20-27) for modular filter Install your modular filter holder easily with these 20/27 (3/4") connectors |
|
Double connector for modular filter Connect your modular filter holders together easily. |
|
Filter cartridge centring device An essential accessory for filter doors. These rings make it easy to centre the filter cartridges so that they are properly aligned when reassembled. |
|
A cheap price for your activated carbon and sediment filter cartridges |
|
Pleated washable cartridge - 5 microns Washable, longer-lasting cartridges!
For standard 10" inch filter holder. |
|
5 micron sediment cartridge 10 inches Efficient deposit filtration.
For 10-inch filter holders. |
|
Activated carbon cartridge Block 10 inch 10 microns Replacement cartridge for activated carbon filtration 10 µm.For 10 inch filter doors. |
|
Activated carbon cartridge - GAC Coconut granule activated carbon
High-efficiency cartridge.
|
|
Silver activated carbon cartridge - KDF GAC NS Bacteriostatic activated carbon
Anti-bacterial.
Cartridge suitable for 10-inch filter doors. |
|
Mixed cartridge - activated carbon - sediment Unique filtration cartridge for the whole house!Ideal for use with a 1-tank water filter compact 2-in-1 cartridge:
The essentials of water treatment in a single filter cartridge. |
|
Specifically designed to remove iron, manganese and hydrogen sulphide
|
|
Anti-fluorine and arsenic cartridge - FLAR For 10-inch filter holder - FLAR
|
| Sub total: | 90,00 € | |
English 
Français 
Deutsch 
Italiano 
Español 
Polski 
Türkçe 
Svenska 
Nederlands 
Belgium